● Features:

1.These nozzles atomize liquids completely using compressed air, gas, or vapor pressures.

2.All models use liquid differential pressure to control the flow rate.

3.The spray angle of the nozzles can be set between 10° and 40° depending on the spindle position.

4.The droplet size depends on the mass ratio per kg of atomizing medium to per kg of water.

5.In some cases, you can achieve a liquid control range of 1:10 (with 1:30 possible).

6.The two components do not mix before leaving the nozzle orifice.

7.Needle types without liquid control excel at breaking down thick liquids.

8.You can install a full cone spinner or a triple slot rotator in the Liquidless Control Needle Type. Factors such as controllability, contamination risk, and viscosity determine this. Use the spinner for pre-atomization. Triple slot rotators achieve better pre-atomization but are more prone to clogging.

9.Standard nozzle models have a screw fitting. It allows for easy mounting on a flange or tank wall.

10.Within certain limits, you can also use this series of nozzles as injectors.

11.Use this nozzle for larger reaction or exchange surfaces. It suits higher flow rates and viscosities.

1.Adsorption Coating Combustion

2.Finishing Fluidized bed technology

3.Granulation Mixing Thickening

4.Oil and alcohol recovery Process engineering

5.Spray drying Tobacco industry

● material：

1.Brass
2.Titanium
3.Acid Resistant Stainless Steel
4.Chromium-nickel-iron alloy
5.Heat Resistant Stainless Steel
6.Hastelloy           
Customized products from other materials are available upon request